Flying like a bird

Featured

I did it! This weekend I brought out my wings again for a second test. And here it is. Do I need to say more? Just watch the video

FacebookShare

Podcast about my project

Three geeks who call themselves Three’s a Quorum made a great podcast about ‘the least important news of the day’, and my project is one of the items they talk about. It’s fun stuff to listen to.  So here it is.

Here’s the bit where they talk about my Human Birdwings project.
Three is a Quorum about Human Birdwings (click it, and it will play)

And here is the original link: http://3aq.tumblr.com/post/16799334255/ep-3-hawkmen-attack

FacebookShare

First test with wings!

The wings did their job! The stakes were high for me, so I was disappointed that I only made a tiny hop in the air. But it worked!

While I was getting bored with the bad weather, I tried the wings in the factory floor below my workplace earlier. And that tiny pre-test proved that I could go outdoors to try the real thing. Although the weather this week didn’t look good at all! Yesterday in the afternoon the sun returned for just a couple of hours. So I prepared the wings with my crew a.s.a.p. and jumped in the van to the testinglocation.

Here it is guys. Enjoy!

FacebookShare

Working on the wings

So what are these wings all about, you might think?

In the latest videos you have seen me working on flightpins and the wingsurface for which I have sacrificed my Slingshot Fuel 17m2 kite for the membrane wingsurface. 

vleugeltekening

This  fabric weighs about 70 grams per square meter, so in total that will be around 1050 grams. It’s quite a challenge to work with this fabric. It’s strong, but at the same time very fragile. Especially because of the forces it has to cope with during the flights, it’s important to Continue reading

FacebookShare

Aerodynamic ribs & wingsurface

To keep you updated, here are my latest videos on the construction of the wing. Half december things have been progressing steadily. Floor did a nice job filming that, so here the result.

In the first video you see how I had the aerdynamic ribs cut at a technical workplace. The ribs give the wing its shape. We have succesfully attached them to the flightpins. The second video gives you a nice look at the completions of the wing. The work is not quite done yet, the mechanics of the wing needs to be calibrated, balanced and finetuned.

But isn’t it just great the wings have come off the drawing table and now hang in my workplace? I am tired but so excited!

FacebookShare